Topic: "Numerical investigation of wave induced enhancement of boron removal in gas blowing silicon refinement".
Scientific supervisor: Dr. phys. Vadims Geža.
Abstract:
As the world transitions towards green energy, the demand for solar grade silicon is increasing due to the growing importance of photovoltaics in the market. One of the industrial steps to obtain solar grade silicon can be gas blowing refinement, which removes unwanted impurities from silicon, including boron. This dissertation aims to numerically model gas blowing refinement and to investigate the possibility of increasing the efficiency of this process by introducing surface waves on the silicon melt during gas blowing refinement. The current state of research for the metallurgical production of solar grade silicon, particularly for the gas blowing refinement process for boron, is given. Numerical models are constructed based on this - first, a simplified model that assumes boron mass transfer from the melt to the gas is effectively a one-step diffusion process; then, a full gas blowing model is constructed that simulates all mass transfer steps for boron from the melt to the gas phase. The simplified model is used as a proof-of-concept to check whether waves can increase process efficiency. Afterwards, the full model is built to study the process more in depth. The full model is a novel result, as detailed two-phase mass transfer modeling is presently a relatively rare undertaking in scientific literature, and no such model exists for the specific application - thus, it is described in detail. Both models are calibrated against experimental results found in literature. In both cases, the results point to the fact that introducing waves on the silicon melt surface can significantly improve boron mass transfer from the melt to the gas. Wave amplitude and wave steepness are singled out as important factors that determine how beneficial the waves are to mass transfer. Specific mechanisms why these factors impact boron mass transfer are discussed. Ultimately, evidence points toward the fact that introducing surface waves during gas blowing refinement could potentially be an attractive industrial solution well worth the cost.
Reviewers:
- Ph.D. Artūrs Brēķis, University of Latvia;
- Dr. phys. Kaspars Dadzis, Leibniz University Hannover, Germany;
- Dr. Sven Eckert, Helmholtz Dresden-Rossendorf Research Centre, Germany.
The doctoral thesis is available at the LU Library, Raiņa bulvāris 19.
Participation in the online session is by prior application, writing to sintija.silina@lu.lv by 10th of November.